10. Coupling case section

11. Holder of an epiploon

12. Laying

13. Maslootrazhatel

14. Epiploon

The drainage opening of an epiploon has to be turned down.

1. Holder

2. Maslootrazhatel

3. Drainage opening of 4 mm

4. The demountable plane with the pallet

1. Remove transmission, designate orientation and remove coupling and a flywheel.

2. Remove a back intensifying plate and the lower section of a case of coupling.

3. On the diesel carefully separate laying from the lower part of the holder of an epiploon. At damage of laying remove the pallet and replace laying.

4. On cars with consolidation of the pallet sealant remove the pallet and remove the sealant remains.

5. Turn off bolts and get the holder with an epiploon, remove laying.

6. Shoot a maslootrazhatel (with parts of cars) and get an epiploon.

7. Check wear of the condensed crankshaft neck. At deep development replace the crankshaft.

8. Installation is carried out upside-down. Press an epiploon so that its surface was aflush with the holder's plane. Replace laying and tighten the holder's bolts with m 11 N.' moment.

1. Epiploon

2. Screw-driver

3. Crankshaft

Arrow – the place of lubricant.

Removal and installation

1. Remove transmission. Holding the crankshaft or a flywheel, turn off bolts and remove coupling and a flywheel (or a drive plate of the hydrotransformer).

2. Make an incision and remove an epiploon, having hooked on flat-nose pliers.

3. Check wear of the condensed crankshaft neck. At deep development replace the crankshaft.

4. Installation is carried out upside-down. Press an epiploon a mandrel, having greased working edges.