1. Filter

2. Air offtake

3, 4. Branch pipe

5. Arm

6. Cover

7. Oxygen sensor

8. Samopodzhimny nut

9. Flange of an exhaust pipe

10, 13. Laying

11. Hook

12. Collector

1. Disconnect the battery from weight. Remove the air filter.

2. Disconnect an exhaust pipe from a collector (if necessary lift the car and turn off bolts from below).

3. Disconnect an air duct, a mass wire and a hose. Remove an arm of the valve and a cover of a collector.

4. Grease nuts of a collector with the getting liquid. Turn out the oxygen sensor.

Turn off nuts and remove a collector with the reed valve and a branch pipe.

5. Clear the demountable planes of a collector and a head of cylinders.

6. Installation is carried out upside-down.

Replace laying, nuts of a collector and the damaged hairpins, having turned out them by means of 2 zakontrenny nuts. Delay all connections with the moments specified illustrations for the engine of 2,6 l.

1. Cover

2, 5. Laying

3. Oxygen sensor

4. Collector

1. Disconnect the battery from weight. Remove the air filter.

2. Uncover a collector.

3. Lift a front of the car and disconnect an exhaust pipe from a collector.

4. Turn out the sensor of oxygen and disconnect a wire on weight.

5. Turn off nuts and remove a collector.

6. Installation is carried out upside-down. Replace laying. Delay all connections the required moments.

1. Oxygen sensors

2, 3. Exhaust pipes

4, 10, 17. Laying

5. Air duct

6, 13. Guard

7. Hook

8. Generator arm

9, 16. Collector

11, 12. Tube and laying

14. Rack of the leveling camera

15. Arm

1. Remove the battery and a tray.

2. Disconnect exhaust pipes from a collector and fix them by a wire.

3. Remove a thermal guard of a collector.

4. Disconnect a recirculation tube with laying on both sides.

5. Remove a rack of an inlet collector with an arm.

6. Turn off nuts and remove a collector.

7. Installation is carried out upside-down. Replace all laying. Delay all connections the required moments.

1. Disconnect weight. Remove an air duct.

2. Disconnect exhaust pipes from a collector and fix them by a wire.

3. Remove a thermal guard, the right hook and a prop of the generator from a collector.

4. Turn off nuts and remove a collector.

5. Check the collector plane. And with the sdeformirovanny plane (a deviation from caliber over 0,3 mm) replace a collector with cracks.

6. Installation is carried out upside-down. Replace all laying. Delay all connections the required moments.

1. Guard

2. The collector is right

3, 6. Laying

5. The collector is left

1. Recirculation tube

2, 5, 8. Laying

3, 6. Guards

4. The collector is right

5. The collector is left

1. Remove the battery and a tray.

2. Disconnect exhaust pipes from a collector and fix them by a wire.

3. Remove a thermal guard of a collector.

4. Turn off nuts and remove a collector.

5. Check a condition of a collector. And with the sdeformirovanny plane (a deviation from caliber over 0,3 mm) replace a collector with cracks.

6. Installation is carried out upside-down. Replace all laying. Delay all connections the required moments.

1. Disconnect weight. Remove an air duct.

2. Disconnect exhaust pipes from a collector and fix them by a wire.

3. Remove a thermal guard from a collector.

4. Turn off nuts and remove a collector and laying.

5. Check the collector plane. And with the sdeformirovanny plane (a deviation from caliber over 0,3 mm) replace a collector with cracks.

6. Installation is carried out upside-down. Replace all laying. Delay all connections the required moments.