12:28. Switch of the door lock
The door lock and the handle of a lobby (above) and a back door (on inserts – places of lubricant at assembly)
1. Button of blocking of the lock
2. Handle
3. Bracket
4. Lock switch
5. Lock mechanism
6, 7. Electric drive
The door lock and the handle of a back cover (1992-98) (on an insert – the place of lubricant at assembly)
1. Facing of a lamp of illumination of registration plate
2. Handle
3. Lock mechanism
4. Electric drive
5. Bracket
6. Lock switch
The door lock and the handle of a back cover (1992-98) (on an insert – the place of lubricant at assembly)
1. Internal panel and water filter
2. Arm
3. Facing
4. The handle is external
5. The handle is internal
6. Lock
7. Electric drive
Removal and installation
|
Prevention
At dismantle of door locks a part of fastenings of drafts of the mechanism of the drive of the lock will be damaged therefore for assembly prepare new fastenings (brackets, latches, etc.)
|
PERFORMANCE ORDER
1. Lower glass and remove the internal panel of a door.
2. Carefully remove a windowpane sealant.
3. Remove brackets of fastening of thirsts of the lock for the handle and a drum of the switch (on a part of cars it is recommended to disconnect drafts on the lock mechanism).
The lock switch which is built in in the handle
4. Disconnect sockets of wires.
5. Turn off nuts and remove the handle. The lock should be removed from the handle in a workshop with the qualified specialist.
6. Installation is carried out upside-down.
The lock switch which is built in at a door
7. Remove a horseshoe bracket and remove a drum of the switch. Repair
the switch is under repair in a workshop the qualified specialist.
8. Installation is carried out upside-down.
Switch of the lock of a back cover
9. The procedure differs in nothing from described for door locks.