1, 2. Bolt

3, 8, 9. Washer

4. A support pillow from a body

5. Pillow And

6. Plug

7. A pillow In

10. Limiter

11. Samopodzhimny nut

12. Laying (till 1993)

N – at assembly is subject to replacement

1, 9. Bolt

2, 6. Washer

3. Pillow And

4. Plug

5. A pillow In

7. Samopodzhimny nut

8. Laying

N – at assembly is subject to replacement

1, 8. Bolt

2, 6. Washer

3. Pillow And

4. Plug

5. A pillow In

7. Samopodzhimny nut

9. Laying

If performance of any works it is necessary to remove bolts of fastening of a body, then the body should be raised only on height with which access is provided, it is forbidden to lift a body on the considerable height as breakages are possible.

If it is necessary to replace any fastening of a body, then it is necessary to turn off all bolts of fastening of a body on this party and to establish under a support body about each of fastenings.

1. Lift the car, establish supports under each support, having laid wooden whetstones. At least establish one support under a frame.

2. Turn off bolts of support of a body from that party on which work is performed. At an opportunity remove a washer and the lower pillow.

3. Remove a support from under a frame and carefully you priopustit a frame from that party on which work is performed, do not allow excessive lowering of a frame.

4. Again establish a support under a frame.

5. Remove the top pillow, the plug and laying.

6. Establish body support details upside-down.

7. Tighten nuts of support according to the required moments.