1. Socket

2. Pin

3. Door

4, 5. Loops

6. Clamp

7. Adjusting plate

8. Switch cap

9. Trailer switch

10. Limiter

1. Remove facing of a doorway.

2. For access to wires remove the facing panel of a forward mudguard.

3. Disconnect all wires conducting to a door and take aside.

4. Establish a prop under a door and outline contours of loops.

5. Remove overlays of loops, remove a small pin of the limiter of a door.

6. Turn off bolts of fastening of loops to a door (the assistant has to hold at the same time a door).

7. Together carefully remove a door, without allowing loss of adjusting plates under loops. Remember number and an arrangement of plates on each of loops.

8. Installation is carried out upside-down.

9. Establish a door on the outlined contours, establish plates in a former order.

10. Delay fastenings according to the required moments.

11. Adjust a door (see subsection 12.12).

1. Remove an overlay of powder.

2. Remove an overlay of an average rack.

3. Disconnect all wires, leaders from a rack to a door, and take aside.

4. Establish a prop under a door and outline contours of loops.

5. Remove a small pin of the limiter of a door.

6. Turn off bolts of fastening of loops to a door (the assistant has to hold at the same time a door), together carefully remove a door.

7. Installation is carried out upside-down.

8. Establish a door on the outlined contours.

9. Delay fastenings according to the required moments.

10. Adjust a door (see subsection 12.12).