1.3.1. Electronic system of door locks


Block of remote control

1. The button closing locks of doors (LOCK)
2. The button opening locks of doors (UNLOCK)
3. Indicator lamp

Press the button of remote control, and locks of all doors will be open or closed according to your desire. When pressing the LOCK button or the UNLOCK button the indicator lamp lights up.

How to close locks of doors
Press the LOCK button, and locks of all doors will be closed. If you close locks and the ceiling plafond is established in situation (), the plafond has to blink twice.

Opening of locks of doors
By single pressing of the UNLOCK button only the lock of a door of the driver opens.
If you open locks, and the ceiling plafond is established in situation (), it lights up on 3 with.

How to open locks of doors
To open all locks, press the UNLOCK button once again.
The electronic system of locking of doors does not work if you left a key in the door lock or all doors are open.
If when pressing the UNLOCK button during 30 c any door is not open, then locks of all doors will automatically be closed.
Remote control works in a radius of 10 m from the center of the car. Despite it, the radius of work of remote control can change if the car is near a television tower, power plant or radio station.

If when pressing buttons of remote control the phenomena provided below, then, perhaps are observed, it is necessary to replace the battery of the remote block:
– locks of doors do not open or are not closed;
– the indicator lamp burns very dimly or at all does not burn.

Do not leave remote control where there can be its heating caused by hit of direct sunshine.

If you lost remote control, address your dealer for replacement of management.

Prevention
The block of remote control represents very exact electronic device. Therefore take the following into account:
– do not subject remote control to influence of electric current;
– you hold remote control dry;
– do not disassemble the block of remote control.
Modification and carrying out the modifications which are not approved by the producer can cause refusal in the right to use this equipment.