Prevention The drain stopper of transmission is provided only on a part of cars. The liquid replacement procedure in this case differs in nothing from described below, behind that exception that instead of removal of the pallet it is necessary to turn off a stopper.

1. Drain stopper

1. The lower mark for cold liquid

2. The top mark for cold liquid.

3. The lower mark for hot liquid

4. The top mark for hot liquid

1. Right after a trip also install the car on supports. Install the pallet under a transmission case.

2. Carefully remove the pallet, at first having partially turned off bolts and having slightly knocked, and then having finally turned out bolts. Merge liquid. Check a condition of liquid. If liquid of black or dark brown color, or extends a "burned" smell, then it is necessary to hand over the car in car service for check of transmission.

3. Turn off bolts of fastening and remove the filter. Replace the porous filter.

Wash out the mesh filter in solvent and dry.

4. Install the filter and carefully washed out pallet upside-down, having replaced laying. Tighten pallet bolts in the diagonal sequence with m 17 N.' moment.

5. Fill in in fresh liquid in necessary quantity to the lower mark in the probe.

To pour liquid it is not allowed.

6. Start the engine and transfer the selector lever from situation P to all other provisions, then again to situation P. Check the level of transmission liquid. Add to the lower mark. Make a trip, again check level and bring to the top mark, the corresponding heated-up transmission.