1. Lift a car front, remove a wheel, the panel of protection covered also a mud-reflector.

2. Remove the shock-absorber.

3. You will hang out the lower lever a jack and unload the torsion, having turned off an adjusting nut of a bolt of the lever of the torsion.

4. Disconnect a brake hose, release a hose from an arm on the top lever.

5. Remove an arm of the buffer and an arm of a hose of a brake.

6. Rasshplintuyte nut and vypressuyta top spherical support stripper of MB990809-01 or equivalent.

7. Vypressuyte finger of steering draft.

8. Turn off nuts and bolts of an axis of the lever, remove adjusting washers and remove the lever.

9. Installation is carried out upside-down taking into account the following.

10. Establish adjusting washers in a former order, tighten lever axis nuts at first with m 54 N.' moment, after lowering of the car – with m 100–120 N.' moment.

11. Tighten a nut of steering draft with m 60–90 N.' moment, bolts of the buffer of an ogarnichitel – with m 9–14 N.' moment.

12. Adjust the torsion (see subsection 10.2.1), pump over brakes.