10.4.3. Ignition lock
Ignition lock assembled
1. Ignition lock
2. The switch of the reminding signal
Order of removal of the lock of ignition
1. Casing
2. Binding
3. Ignition lock
4. The switch of the reminding signal
The timer of illumination of a nest of the lock (V) and the reminding sound signal (And)
The order of removal installation is identical to all cars. On the car of 1992-98 the lock nest illumination ring, the timer and the reminding sound signal are in addition provided (are mounted respectively on the lock, right and left intensifying arms of a partition of salon).
Removal and installation
PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. On the car of 1992-98 remove the lower facing of the forward panel of salon.
3. Remove both casings of a steering column.
4. Remove a conducting binding, disconnect the ignition lock socket through an opening in a steering column.
5. Unscrew 2 screws of fastening of the switch of a reminder on the left key and remove the ignition lock.
6. Installation is carried out upside-down.
Check
PERFORMANCE ORDER
1. Disconnect the socket and check a chain between ignition lock conclusions according to the scheme and the table.
2. If contacts do not become isolated according to the table, then replace the lock of ignition.
The table for check of isolation of contacts of the lock of ignition at different provisions of a key (1983-86)
The table for check of isolation of contacts of the lock of ignition at different provisions of a key (1987-91)
The table for check of isolation of contacts of the lock of ignition at different provisions of a key (1992-98)