1. Disconnect a high-voltage wire on the ignition coil.

2. Rotate a wheel in both parties, including a starter on 15–20 sec.

3. Repeat the last operation of 5-6 times, watching liquid level in a tank of the hydraulic booster. Level at turn of a wheel should not change.

4. Attach a wire and start the engine, idling rotate a wheel in both parties against the stop.

5. Change of level at turn of a wheel should not exceed 5 mm, and liquid should not be uniform (without small bubbles). If level changes stronger or if after switching off of the engine level sharply increases, then in the hydraulic booster there is an air.

6. Add liquid and close a tank a stopper.

7. Establish a spare wheel and fix by bolts, having tightened them it is insignificant.

8. Lower a wheel. In the diagonal sequence tighten bolts of fastening of a wheel demanded the moment.