1. Reducer

2, 3. Holders of the bearing of the leading gear wheel of the main transfer

4. Adjusting washer

5. Epiploon

6. Flange

7. Washer

8. Samopodzhimny nut

1. Lift the car, merge oil from a reducer.

2. Put orientation tags and disconnect the back driveshaft.

3. Measure the moment of resistance to a provorachivaniye of the leading gear wheel of the main transfer which has to be 0,4–0,5 N. in m, this moment should be sustained at assembly.

4. Holding a flange, turn off a nut and remove a washer.

5. Get a flange of the leading gear wheel, hook and get a reducer epiploon.

6. Assembly is carried out upside-down.

7. Press a new epiploon a mandrel so that the surface of an epiploon was aflush with the reducer plane.

8. Tighten a flange nut, checking the moment of resistance to a provorachivaniye of the leading gear wheel, the final moment of an inhaling of a nut has to be 190–250 N. in m.