1. Regulator of the emergency brake

2. Cable nuts

3. Guard

4. Cable of the emergency brake

5. Drums

6. Tubes

7. Nuts

8. Half shaft

9. Driveshaft

10. Reducer

1. Back brake

2. Disk

3. Bolt of fastening of a cable

4. Tip of a cable of the emergency brake

5. Half shaft

6. Driveshaft

7. Socket

8. Hose

9. Reducer

1. Lift the car and remove back wheels.

2. Merge oil from a reducer of the back bridge.

3. Remove drums, disconnect a cable of the emergency brake and a tube of a hydraulic actuator.

4. Turn off nuts and nominate half shafts from differential approximately to 76 mm.

5. Put orientation tags and disconnect the back driveshaft.

6. Turn off nuts and remove a reducer, having substituted the cart with a jack.

7. If necessary fix a reducer by the top nut and displace from the place blows through wooden whetstone, having opened consolidation.

8. Installation is carried out upside-down.

9. Grease the demountable planes of a reducer and a beam of the bridge with sealant 3M ART N 8661 or N 8663 or equivalent.

10. Tighten nuts and bolts according to the required moments.

11. Upon termination of remove air from a hydraulic actuator of brakes.

1. Remove a disk and a support of a back brake. A support take aside and fix.

2. Disconnect a cable of the emergency brake and a tube of a hydraulic actuator.

3. Turn off nuts and nominate half shafts from differential approximately to 76 mm.

4. Put orientation tags and disconnect the back driveshaft, if necessary get a shaft from the check point.

5. Disconnect from the back bridge the socket of conducting and a hose (on a part of cars).

6. Turn off nuts and remove a reducer, having substituted the cart with a jack.

7. If necessary fix a reducer by the top nut and displace from the place blows through wooden whetstone, having opened consolidation.

8. Installation is carried out upside-down.

9. Grease the demountable planes of a reducer and a beam of the bridge with sealant 3M ART N 8661 or N 8663 or equivalent.

10. Tighten nuts and bolts according to the required moments.

11. Upon termination of remove air from a hydraulic actuator of brakes.