1. Screw

2. Tags

3. Bubble

4. Scale of the vertical indicator

1, 4. Screw

2. Adjustment

3. Scale of the horizontal indicator

5. Scale

6. Black tag

7. Red tag

Shooters specified fastening screws.

1. Horizontal of the center of a headlight

2. Vertical of the center of a headlight

3. Center of an ellipse

4. Zone of high illumination

On these cars the bunch needs to be adjusted only after removal of a headlight, this procedure does not belong to obligatory, carried out as the current maintenance.

1. Install the car on the flat platform, pump over a suspension bracket.

2. Pressure in tires has to meet standard, the tank has to be completely filled (imitation by freight at the rate of 0,8 kg/l of fuel is allowed), and the seat of the driver is loaded weighing 70 kg.

3. Clear headlights.

4. Adjust a vertical angle of a bunch for what rotating the adjusting screw, achieve that the bubble of a vertical goniometer was established between two adjusting tags. The vertical angle at turn on 1 division changes on 12.

5. Adjust a bunch across for what rotating the adjusting screw, achieve combination of red and black tags of the indicator. The corner across at turn on 1 division changes on 23'.

6. If the bunch cannot be adjusted in such a way, then address to car service.

The bunch is regulated with use of the marked screen.

1. Install the car on the flat platform in 3 m from the screen, pump over a suspension bracket.

2. Pressure in tires has to meet standard, the tank has to be completely filled (imitation by freight at the rate of 0,8 kg/l of fuel is allowed), and the seat of the driver is loaded weighing 70 kg.

3. Clear headlights.

4. Define the center of a headlight for a marking and draw (paste) a cross hairs which centers are located opposite to the centers of headlights.

5. Rotating adjusting screws, establish a light ellipse of passing beam of headlights as it is required. Adjustment of driving beam at the same time is not required.