1. Box clamps for trifles

2. Cable of the drive of the gate of a distributive box

3. Handles

4. Cap

5. Central section

6. Socket

7. The lower cover of an air duct of a niche for legs

8. Air duct of heating of a windshield

9. Cable of the delitelny gate

10. Crane drive cable

11. Control panel

12. Switch of the block of an obduv

1. Clamps

2, 16. Cable of the drive of the gate of a distributive box

3, 14. Crane drive cable

4. Lower panel

5. Air ducts

6, 15. Cable of the delitelny gate

7. Central section

8. Control panel of a heater

9. Facing

10. Handles

11. Switch of the block of an obduv

12. Conditioner switch

13. Spring brackets

1. Remove a box for trifles.

2. Disconnect a cable of the gate of a distributive box, having unbent a spring bracket.

3. Remove from the handle control panel.

4. Remove caps, unscrew screws and remove the central section of the forward panel. At removal disconnect the socket from the back.

5. Remove the lower covers of air ducts on the forward panel.

6. Remove an air duct of heating of a windshield.

7. Disconnect cables of management of a heater.

8. Remove a heater assembled.

9. Disconnect the socket and remove the fan switch.

10. Installation is carried out upside-down.

11. Before accession of cables transfer the corresponding levers of gates and the crane to extreme provisions and fix covers of cables by spring brackets.

12. After assembly check completeness and freedom of movement of rychazhok of management.

1. Remove a box for trifles.

2. Unbend spring brackets and disconnect cables of the gate of a distributive box and the gate of a temperature regulator.

3. Remove from the handle control panel.

4. Remove side caps, unscrew screws and remove the central section of the forward panel. At removal of the panel disconnect the socket from the back.

5. Remove the lower cover and air ducts of the left side nozzle and an obduv of a niche for legs.

6. Disconnect a cable of the delitelny gate.

7. Turn off bolts and remove managements of a heater.

8. If necessary remove facing, handles and switches.

9. Remove spring brackets of fastening of covers of cables, having wrung out them in the directions A and B and remove cables (1 – a bracket; 2 – cable).

10. Installation is carried out upside-down.

11. For accession of a cable of the gate of a distributive box press to the full the lever in the direction specified by an arrow.

12. For accession of a cable of the gate of a temperature regulator press to the full the lever in the direction specified by an arrow.

13. For accession of a cable of the delitelny gate press to the full the lever in the direction specified by an arrow.

14. Fix covers of cables by spring brackets.

15. After assembly check completeness and freedom of movement of rychazhok of management.