1. The switch on a steering column

2. Side facing

3. Relay of collaboration of a cleaner and washer

4. Brush

5. Lever

6. Caps

7. Plug

8. Electric motor

9. Draft

10. Tank

11. Electric motor and pump

12. Hose

13. Nozzle

and. Till 1993.

. After 1993.

1. The switch on a steering column (it is combined with the switch of an omyvatelyaa of the relay of sovmetsny work of a cleaner and washer)

2. Switch of a cleaner and washer

3. Hose

4. Nozzle

5. Cap

6. Hose

7. Tank

8. Pump

9. Brush holder

10. Lever

11. Cowl

12. Panel

13. Hatch cover

14. Electric motor

15. Draft

1. Switch

2. Facing panel of a mudguard

3. Relay

4. Internal handle

5. Internal panel of a door and water filter

6. Brush

7. Lever

8. Cap

9. Washer

10. Sealant

11. Cleaner electric motor

12. Sidewall panel

13. Tank

14. Washer electric motor

15. Hoses and nozzle

and. Till 1993.

. After 1993.

1. Switch

2. Relay

3. Brush

4. Cover

5. A brush with the lever

6. Electric motor

7. Sealant

8. Nozzle

9. Tank

10. Hose

11. Electric motor

1. Disconnect the battery from weight.

2. Unscrew screws and remove an overlay of the handle of a back door.

3. Remove an overlay of a door of a back compartment (see subsection 12.25).

4. Remove a cap and turn off a brush lever nut.

5. Remove the lever.

6. Turn off a nut and remove a washer and a sealant from an engine shaft.

7. Disconnect wires, turn off bolts and get the electric motor from a door.

8. Remove the back facing panel of a sidewall.

9. Disconnect wires, turn off bolts, and remove a tank with the pump of a washer of back glass and the electric motor.

10. Installation is carried out upside-down.

11. Tighten cleaner electric motor bolts with m 10 N.' moment, a drive nut – with m 8–12 N.' moment, an electric motor shaft nut – 7–10 N. of m.

12. Establish a brush so that it it was parallel to the lower edge of a window.

13. At installation of brushes it is necessary to sustain the following sizes (the sizes out of brackets – in mm).

1. Disconnect the battery from weight.

2. Remove a cap, turn off a nut of the lever of a brush and remove the lever.

3. Remove an overlay of a door of a back compartment (see subsection 12.25).

4. Disconnect wires, turn off bolts and get the electric motor from a door.

5. Disconnect wires, turn off bolts, and remove a tank with the pump of a washer of back glass and the electric motor.

6. Installation is carried out upside-down.

7. Tighten bolts of the electric motor of a cleaner tighten with m 25 N.' moment, a lever nut – with m 8–12 N.' moment, an electric motor shaft nut – 8 N. of m.

8. At installation of brushes it is necessary to sustain the following sizes: And – 25–35 mm, In – 35–45 mm (R and L – tags of the left and right brushes).

9. At installation of a brush the size A has to be 65–75 mm.