1. Control valve

2. The pitting valve

1. Guard

2. An accelerator cable nut In

3. Nut of a cable of an accelerator And

4. Cable

5. Socket

6. Drive

7. Accelerator switch

8. Braking signal switch

9. Coupling switching off sensor

10. Delay mechanism switch

11. Speed sensor

12. Switch cruise control

13–15. Overlays of a doorway and body

16. Control unit

1. Guard

2. An accelerator cable In

3. Cable of a butterfly valve

4. Cable cruise control

5. Coulisse

6. Arm

12. Main switch

13. Lower overlay of a column

14. Sockets

15. Safety cushion module

16. The operating perelyuchatel

19. Speed sensor

20. Braking signal switch

21. Coupling switching off sensor

22. The blocking automatic transmission switch

23. Sensor of turn of a butterfly valve

1. Disconnect the socket from the vacuum pump.

2. Check resistance between couples of conclusions 1-2 and 1-3 which has to be 60 Ohms.

3. Check operation of the valve at connection of the battery between couples of conclusions 1-2 and 1-3.

4. Replace the valve if its work differs from described.

1. Disconnect the socket from the vacuum pump.

2. At connection of the battery between conclusions 1–4 drive have to rotate.

3. Otherwise replace the drive

1. Disconnect the battery from weight.

2. Remove a drive guard.

3. Release nuts of covers of cables and disconnect cables from the drive.

4. Disconnect the socket from the drive.

5. Turn off 3 nuts and remove the drive.

6. Disconnect wires from an accelerator, the switch of a signal of braking, the sensor of switching off of coupling and a delay mechanism, remove switches.

7. Remove a combination of devices (see fig. subsection 13.16), remove the speed sensor from a speedometer.

8. Remove from a steering column the switch a cruise control.

9. Remove an overlay of an aperture of a forward door, an overlay of powder, a side casing and the control unit.

10. Installation of the removed knots of system is carried out upside-down.

11. Tighten nuts of cables with m 8–11 N.' moment.

12. Disconnect all cables from the coulisse.

13. Turn off 4 nuts and remove the coulisse.

14. Turn off a bolt and remove an arm.

15. Disconnect the socket and a hose from the vacuum pump and remove the pump.

16. Turn off 3 nuts and remove a pump arm.

17. Remove the drive.

18. Installation of the removed knots of system is carried out upside-down.

19. Adjust cables, having executed the following.

20. Keeping the coulisse With and resting against the limiter, wrap a cable cover nut so that the free wheeling of a cable was 2–3 mm, tighten a lock-nut.

21. Keeping the coulisse In and resting against the coulisse With, wrap a cable cover nut at the released bolt so that the free wheeling of a cable was 1–2 mm, tighten a lock-nut.

22. Keeping the coulisse And yes resting against the coulisse In wrap a cable cover nut so that the free wheeling of a cable was 1–2 mm, tighten a lock-nut.